How it works
The rollers are set alternately at 90° to each other in a cage between two V-section raceways. They do not recirculate — they travel together with the cage, and the stroke is limited by the length of the guide. Contact between roller and raceway is a line rather than a point, so for the same dimensions the load rating and rigidity are higher than in a design with balls as the rolling elements.
The absence of recirculation has a second advantage that matters for precision: the difference between static and dynamic friction is minimal. The table starts without a jerk and can be set with repeatability in the micrometre range. Running is also quiet.
The version with the STUDROLLER system addresses a typical weakness of non-recirculating guides: over time the cage drifts off centre and loses synchronisation with the table. The STUDROLLER mechanism prevents this and also makes room for up to 53% more active rollers, raising the load rating by as much as 2.3 times compared with the standard version.
When a crossed roller guide is the right choice
- the stroke is short and known
- repeatability over micrometre movements matters
- the machine cannot tolerate a jerk on start-up
- high rigidity is needed at a low installation height
- running must be quiet
- high speeds and accelerations — up to 20 cycles per second
When to reach for something else
If motion has to follow an arc rather than a straight line — GONIO WAY.
Product advantages
- minimal difference between static and dynamic friction — no jump on start-up
- positioning repeatability over micrometre movements
- high rigidity and load rating at a low installation height, thanks to line contact between roller and raceway
- quiet, smooth running across the whole speed range
- STUDROLLER version: protection against cage creep and up to 2.3 times the load rating
Available versions
- guides with rails for your own installation — types NV, SV and HV
- ready-made crossed roller tables for plate mounting
- stainless steel versions — NVS, SVS and HVS series
- STUDROLLER version with protection against cage creep
Dimensions, static and dynamic load ratings and tolerances are available in the catalogue.
Typical applications
- Optics — measuring tables, alignment systems, microscopes — micrometre motion and a stable setting
- Medical devices — diagnostic and laboratory equipment that needs quiet, smooth running
- Automation and robotics — inspection and positioning stations over a short stroke
- Metalworking — alignment axes and measuring assemblies at machines
- Measuring instruments
- Semiconductor manufacturing
We will propose a SLIDE WAY guide for your stroke and load
Load, stroke, speed and operating conditions. That is enough to indicate the type and size of the component.
Enquiry form