Home › Products › Ball splines

Ball splines

Torque and linear motion on a single shaft.

How it works

The shaft has longitudinal grooves with a gothic-arch profile matched to the balls. The balls recirculate in the nut along these grooves, so the nut travels along the shaft and transmits torque at the same time. A standard ball bushing cannot do this: it turns freely around the shaft.

Two types are available. The linear type transmits torque and travel. The rotary type has the nut supported in bearings in a ready-made housing, so the unit performs rotation about its own axis and linear travel independently of each other — this is the solution used in the Z axes of feeders and SCARA robots.

When a ball spline is needed

  • torque and travel along the axis of the spline shaft have to be transmitted at the same time
  • Z-axis work where both rotation and linear travel are needed
  • the application requires preload

When to reach for something else

If torque is not transmitted by the application, a standard ball bushing is enough — SLIDE BUSH, or TOPBALL® at higher loads. If only rotation is needed, without travel, that is a job for a rolling bearing, not a ball spline.

Product advantages

  • two motions in one joint — a lighter design
  • torque transmission with low resistance to travel
  • ready-made rotary units that shorten Z-axis design
  • compact installation
  • smaller size and weight of the machine — one BALL SPLINE replaces two standard SLIDE BUSH bushings

Available versions

  • linear type — the nut alone on a spline shaft
  • rotary type (Rotary Ball Spline) — the nut supported in bearings in a ready-made housing
  • combined version with a ball screw (Ball Screw Spline)

Dimensions, static and dynamic load ratings and tolerances are available in the catalogue.

Typical applications

  • Automation and robotics — Z axes of feeders and SCARA robots, gripper heads with rotation
  • Metalworking — feeding and positioning assemblies that transmit torque
  • Medical devices — mechanisms combining rotation and travel in one joint
  • CNC machines — automatic tool change

We will check whether a Ball Spline solves your joint

Load, stroke, speed and operating conditions. That is enough to indicate the type and size of the component.

Enquiry form

Load, stroke, speed, operating conditions, installation conditions, deadline.